Adder-technology SV4 Manuel d'utilisateur télécharger pdf (Page 18)

SmartView Installation and Use Page 17

3.4 Keyboard hotkey control

SmartView can be conveniently controlled by selecting channel, autoscan mode or

security locking from the keyboard. All of the hotkey control commands are invoked

by holding down the two hotkeys and then pressing a command key. By default, the

two hotkeys are ‘CTRL’ and ‘ALT’, although other combinations can be selected by

reconfiguring the hotkeys (see section 4.5). Once the hotkey command has been

activated you will need to release the hotkeys and the command key before a new

hotkey command is accepted by the SmartView. HOTKEYs + TAB is an exception

and this allows you to 'tab through' the ports by holding down the hotkeys and

repeatedly pressing TAB. If the SmartView has been set to cycle between active

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Pas de commentaire

Adder-technology SV4 Manuel d'utilisateur Page 18